GN Air Solutions installs, replaces, repairs and maintains tankless water heaters across the GTA. Get equipment sizing, conversion guidance and professional service matched to your household hot-water demand and existing connections.
Choose the service that matches your situation, whether you are installing a new unit, replacing a storage tank or troubleshooting an existing tankless system.
Professional selection and installation for reliable on-demand hot water.
A tankless water heater must be sized for simultaneous fixture demand and the temperature rise required during GTA winters. GN Air Solutions reviews the home before recommending equipment or connections.
Replace a conventional storage tank with a compact on-demand system.
A conversion may require more than removing the old tank. Gas capacity, vent routing, drain availability, electrical power and water-line arrangement must be checked before the work and quotation are finalized.
Diagnostics, component service and descaling for existing tankless systems.
Error codes and symptoms provide useful clues, but the underlying cause may involve water flow, gas supply, venting, ignition, sensors, scale buildup or controls. Professional diagnosis is the safest path.
This overview helps homeowners understand the basic differences.
GN Air Solutions can assess the property before making a final recommendation.
| Planning factor | Why it matters | What GN Air Solutions reviews |
|---|---|---|
| Hot-water demand | Multiple fixtures may run at the same time | Expected simultaneous flow and usage pattern |
| Temperature rise | Incoming GTA winter water can be cold | Required output at design conditions |
| Gas supply | Tankless units may require higher input capacity | Existing line, meter and appliance demand |
| Venting | Approved material, routing and termination are essential | Location, clearances and available route |
| Condensate | Condensing units require suitable drainage | Drain path and neutralization needs |
| Water quality | Hardness and scale affect maintenance | Filtration, treatment and service expectations |
The unit starts but does not deliver hot water, or it does not start at all.
Water turns unexpectedly cold or varies during a shower or fixture use.
The display shows a recurring code or the unit repeatedly locks out.
Available hot-water volume or pressure is noticeably lower than before.
Water appears around the unit, valves, connections or condensate components.
New noises, delayed ignition or frequent cycling may require diagnosis.
GN Air Solutions plans the complete installation before equipment is selected and connected.
Review demand, utilities, venting, drainage, location and the existing system.
Explain suitable capacity, efficiency and installation options.
Complete required connections, venting, drainage, controls and setup.
Commission the unit and review operation and maintenance requirements.
Installation, replacement, repair and maintenance for homeowners across Toronto, Peel and Durham Region.
A site assessment is the best way to confirm the right solution for your property.
It can heat water continuously while demand stays within the unit’s capacity. If simultaneous fixture flow exceeds that capacity, delivery temperature or flow may be affected.
Many homes can, but the conversion may require gas-line, venting, condensate, electrical or plumbing changes. Existing conditions must be reviewed first.
Sizing depends on expected simultaneous flow and required temperature rise, not only the number of occupants. Incoming water temperature and fixture usage are important.
Follow manufacturer guidance. Frequency also depends on water hardness, usage, filtration and system condition. Hard-water areas may require more frequent service.
Choose installation, conversion, repair or maintenance and describe the system or problem.
© 2026 GN Air Solutions. All rights reserved.
