GN Air Solutions installs, repairs and maintains conventional tank water heaters, high-efficiency tankless units and space-saving combi systems. Get a clear recommendation based on your household demand, available space, existing connections and budget.
Each system has different installation requirements, maintenance needs and advantages. Select your system below for focused service information.
Reliable stored hot water with familiar operation and a lower initial investment.
A conventional water heater stores heated water in an insulated tank, ready for use. It remains a practical choice for many GTA homes and can be replaced with minimal changes when the existing capacity and connections are suitable.
Hot water produced on demand from a compact, high-efficiency wall-mounted unit.
A tankless system heats water only when a fixture calls for it. Correct sizing is essential: the unit must support the home’s expected simultaneous flow while providing the required temperature rise in GTA winter conditions.
One compact system designed to provide both home heating and domestic hot water.
A combi boiler combines hydronic space heating and domestic hot-water production in one appliance. Because it serves two important functions, selection must consider both the home’s heating load and the household’s hot-water demand.
This overview helps homeowners understand the basic differences. GN Air Solutions can assess the property before making a final recommendation.
| Consideration | Tank | Tankless | Combi |
|---|---|---|---|
| How it works | Stores heated water | Heats water on demand | Provides hot water and space heating |
| Space required | Floor space for tank | Compact wall-mounted unit | Compact integrated appliance |
| Best-known advantage | Simple, familiar and economical | Space saving and long-duration hot water | Two home-comfort functions in one |
| Key sizing factor | Storage capacity and recovery | Flow rate and temperature rise | Heating load plus hot-water demand |
| Typical maintenance | Inspection and tank flushing | Inspection and descaling | Annual boiler and hydronic inspection |
The system does not heat, or hot water takes much longer than usual.
Water becomes unexpectedly cold, excessively hot or fluctuates during use.
Moisture near the tank, appliance, piping or relief valve needs attention.
A tankless or combi system repeatedly displays a code or stops operating.
New noises can indicate sediment, scale, circulation or component problems.
Slow recovery, low flow or rising energy use may indicate developing trouble.
GN Air Solutions assesses the home before recommending equipment or beginning work.
Review the existing unit, household demand, plumbing, fuel, venting and space.
Explain suitable tank, tankless or combi choices without unnecessary complexity.
Complete approved connections, drainage, controls, setup and safety checks.
Test operation and show the homeowner basic controls and maintenance needs.
Installation, replacement, repair and maintenance for homeowners across Toronto, Peel and Durham Region.
A site assessment is the best way to confirm the right solution for your property.
Neither is automatically better for every home. The choice depends on hot-water demand, simultaneous fixture use, available space, existing gas and venting, maintenance expectations and budget.
Often yes, but the conversion may require changes to the gas line, venting, condensate drainage, electrical supply or plumbing. GN Air Solutions can assess the existing conditions.
A combi boiler provides hydronic space heating and domestic hot water from one appliance. It must be sized for both demands and is not the right replacement for every home.
Service frequency depends on the manufacturer, water hardness and usage. Periodic inspection and descaling are commonly needed to control mineral buildup and maintain performance.
Choose tank, tankless or combi service and briefly describe the installation or problem.
© 2026 GN Air Solutions. All rights reserved.
